Minsun Technology Co., Ltd- electronic meters, automatic plating machines

繁體中文

　home

　about us

Model: MSES-500

　news

electronic meters/control devices

Digit PowerMeter

MSDP-800

MSDP-300

MSDP-880/ 882

Demand Control

MSDM-900

V and A Meter

MSDP-883

Kilowatt-Hour Meter

MSDP-700/702

PF Regulator

MSPFR-806/ 812

APFR-6

Introduction:

Power Converter

										
											This installment conforms to government 
										stipulation " When employer to laborer 
										in good conductor machinery equipment 
										work, the use AC electric welding 
										machine have to installed Anti-electric 
										shock device " 

											Three function integrated: Automatic 
										anti-shock + electric leakage prevent + 
										standby energy saving.

									

MSDP-200

signal Converter

Signal Transducer

AC Welding Anti-Shock Device

MSES-500

power control system

Features:

Power Control System

							Safety no-load voltage is less than 24V, 
								content electric leakage trip  function, 
								Will all-environment get an electric shock 
								danger to decline to lowest, ensure the safety 
								of the operator. 
Start-up time of less than 0.06s, don't 
								influence the efficiency of electric welding 
								work .
Start-up sensitivity of less than 500 Ohm, 
								when the human body contact with the output 
								lines (including wet places) will not start too, 
								Reach the function of the safety protection .
Standby delay is less than 1 second, when 
								the output voltage up to 80V at no load can be 
								reduced to 24V during 1 second, to prevent an 
								electric shock hazard to the person.

							

Demand Control System

Power Factor Controller

plating machines/accessories

Specifications:

Power input	220V
Output voltage	AC 19V
Control mode	Into electric method
Leakage detector	50mA to prevent leakage of electric welding machine
Status LED	Red (Standby), Yellow (In action), Green (Leakage)

Comparison:

Item	To installation the device	Not to install the device
No-load output voltage of electric welding machine	19VAC can avoid electric shocks	80VAC
Standby power factor（PF）	1	0.18
Standby current	0.1A, can saving electricity	More than 10A
Leakage break-circuit function	Have	Without


		Minsun Technology Co., Ltd
		15, Lane 210, Jeanshin St. Shulin City, Taipei Hsien, Taiwan R.O.C

		Tel : 886-2-2689-4051~2
		Fax: 886-2-2688-0109
		91,GUNGMINGNAN 1 RD., TAINAN, TAIWAN, R.O.C.
		Tel : 886-6-246-4745~6
		Fax: 886-6-246-4750
		E-mail:minsunt@gmail.com
		http://www.minsun.com